How to Install a Smart Doorbell Camera in Minutes

Quick answer

Mount the doorbell bracket, connect the wires to the existing doorbell system, attach the camera, then complete setup in the companion app. Most installations take under 30 minutes.

Step-by-step installation guide

1. Turn off power at the breaker: Locate the circuit breaker for your doorbell and switch it off. Use a voltage tester to confirm no electricity is flowing to the wires. This prevents shock during wiring. Always double-check with a non-contact voltage tester even after flipping the breaker.
2. Remove the old doorbell and inspect wiring: Unscrew your existing doorbell from the wall. Pull it gently to expose the two wires. Do not let the wires fall back into the wall. Inspect the wire ends for fraying or corrosion. If wires are damaged, trim them with wire cutters and strip about 1/4 inch of insulation.
3. Mount the mounting bracket: Position the bracket that came with your G-Home Smart Doorbell over the wires. Use a level to ensure it is straight, then mark the screw holes. Drill pilot holes if needed, then screw the bracket securely to the wall. If the old screw holes don't align, use the provided wall anchors for a firm hold.
4. Connect the wires to the doorbell: Attach the two doorbell wires to the two screw terminals on the back of the doorbell camera. Polarity usually does not matter for AC systems. Tighten the screws to secure the wires. Tuck excess wire into the wall cavity. Loose wires cause intermittent power loss – tug gently on each wire after tightening to confirm it's snug.
5. Attach the doorbell to the bracket: Align the doorbell camera with the mounting bracket and press it into place until it clicks. Some models use a security screw at the bottom – tighten it to prevent theft. Snap on the faceplate if included. If the doorbell doesn't sit flush, check that the bracket is level and wires are not pinched behind the unit.
6. Restore power and set up the app: Turn the breaker back on. The doorbell should light up or chime. Open the companion app (e.g., G-Home app) and follow the on-screen instructions to connect to your 2.4 GHz Wi-Fi. Scan the QR code on the device if prompted. If the app can't find the doorbell, hold the reset button for 5 seconds until the LED blinks, then retry.

Product spotlight

• G-Home Smart Doorbell Security Camera: The G-Home Smart Doorbell Security Camera combines traditional doorbell function with advanced smart technology. You get a single device that replaces your old doorbell while adding HD video and remote alerts, simplifying installation to one unit.